Filter
Top Products
30
Note: If a cassette was loaded when you
last turned off the Model 36, you must
press
POWER
to turn on the Model 36.
2. Repeatedly press
SPEED
until the desired
recording speed (
SP
,
LP
, or
SLP
) appears.
3. Press
CHANNEL
s or t or use the remote
control’s number buttons to select the
desired channel.
4. Press
REC/OTR
twice on the front of the
Model 36 to begin recording. The REC indi-
cator on the Model 36 flashes,
OTR
and
(0:30)
appear for about 5 seconds, and
the Model 36 records what you see on the
TV screen.
5. To change the displayed total recording
time, within 5 seconds repeatedly press
REC/OTR
to advance the time in 30-minute
increments.
Note: If you do not press
REC/OTR
within 5
seconds, the recording time disappears.
Simply press
REC/OTR
again to redisplay
the remaining recording time.
When you finish entering all OTR informa-
tion, the displayed information disappears
after 5 seconds.
When the recording stop time is reached during
OTR recording, the Model 36 turns off.
Notes:
• To turn the TV picture off or on while
recording, press
POWER
.
• To cancel OTR while the Model 36 is
recording, press
STOP/EJECT
on the Model
36 (or
STOP
on the remote control).
SP
OTR Hints
• To ensure that you record all of the desired
program, you might want to set the record-
ing stop time 30 minutes later than the
scheduled end of the program.
• You can program OTR information only
while a tape is recording. You cannot
program OTR information if a tape is not
inserted in the Model 36, if the erase-
protection tab on the tape is removed, or if
automatic timer recording is in progress.
• During OTR recording, the remaining
recording time is displayed for about 5 sec-
onds when you press
REC/OTR
.
• You can check automatic program timer
settings during OTR. See “Automatic Timer
Recording”.
• Be sure the tape length you select for OTR
is long enough to record the entire pro-
gram. Even though you can set the Model
36 to record for up to 8 hours, the actual
recording time is limited by the tape’s
length.
AUTOMATIC TIMER
RECORDING
You can program the Model 36’s automatic timer
to select a channel, start recording a broadcast on
that channel at a time and tape speed you set,
then stop recording at a time you set. You can set
up to 8 automatic program timers to record any
combination of weekly, daily, or one-time broad-
casts on the same or different channels.
You can program the Model 36 to record at any
time on a specific day you set within a 1-year pe-
riod (ONCE), any time at the same time Monday
through Sunday (EVRY DAY), and any time the
same day every week (EVRY and desired day of
the week).
Note: You cannot set an automatic timer record-
ing while you are recording a program.
16-429.fm Page 30 Tuesday, July 20, 1999 3:50 PM