Filter
Top Products
9
ENGLISH
Posts
Figure 14
Before
Holes to Align
Holes to Align
After
Top
Bottom
Figure 13
Slide the element sleeve over the element. Align the holes in the element
sleeve and element. Then, slide the element extension into the element
sleeve. Align the holes in the element sleeve and element extension. Insert a
small screw through the top of each hole, and thread a small fl ange nut onto
each screw. Repeat for connecting each element extension to an element.
See Figure 13.
Attaching a Coax Cable
Locate the two posts on the underside of
the front assembly (Figure 14). Place two
washers on each post. Loosely thread a
small nut onto each post. Slide one fork of
the matching transformer between a set of
washers. Repeat for the other fork on the
other post. Tighten the nuts, making sure
that the forks are still connected.