Filter
Top Products
11
Chapter 1: Connections and Setup
Connect the cables to the G-LINK and/or IR SAT jacks on the back of the Recorder
If you connected a cable box or satellite receiver to the recorder, you must connect the G-LINK cable (provided) in order for all of the Digital
Media Recorder’s features to work correctly.
The G-LINK cable (provided) enables the Digital Media Recorder to control the cable box or satellite receiver so you can set up timer recordings.
Connecting the G-LINK cable also enables the GUIDE Plus+ system (the on-screen programming guide) to list the correct programs.
Note: The GUIDE Plus+ System doesn’t interpret information from satellite programming. It only downloads cable TV listings and/or off-air
broadcast listings. Therefore, there won’t be any program listings in the Digital Media Recorder’s GUIDE Plus+ programming guide if you have
satellite service.
1a. If you connected a cable box, insert the G-LINK cable into the G-LINK jack on the back of the Digital
Media Recorder.
1b. If you connected a satellite receiver, insert the G-LINK cable into the IR SAT jack on the back of the
Digital Media Recorder.
2. Connect the other end of the cable (called a wand) in front of the remote sensor that’s on front of the cable
box or satellite receiver (see picture at the bottom of this page). Some cable boxes and satellite receivers have
the remote sensor labelled, but some don’t. If you see the remote sensor label on your cable box or satellite
receiver, go to step 7 (sometimes it’s labeled IR or remote or sensor). If you don’t see a remote sensor label on
your cable box or satellite receiver, go to step 3.
3. Turn off the cable box or satellite receiver.
G-LINK cable
4. Hold the satellite receiver remote control or cable box remote control so that it is touching the front of the
satellite receiver or cable box.
5. Slowly move the remote control in front of the satellite receiver or cable box while you press the power button
on and off. You must press and release the power button each time you move the remote (holding down the
button won’t work).
6. When the satellite receiver (or cable box) turns on, you’ve located the sensor.
VCR
03
CHANNEL
SENSOR
SENSOR
Attach to the VCR
If you don’t have a cable box, just leave
the extra cord unattached.
7. Place the wand in front of the remote sensor, approximately one inch away from the remote sensor.
Go to page 12
To G-LINK jack on back of
Digital Media Recorder
Satellite receiver
Cable box
Remote sensor
Wand
Remote sensor
Wand
OR