Filter
Top Products
40 Chapter 5
Chapter 5: Commercial Interface Menus
Commercial Interface
OnCommercial Interface
Channel
OSD
Source
Volume
Pillow Speaker
Power Management
RCU and Local Key
Reset Commercial Interface
MENU
Exit
ENTER
Enter Select
FF GG
GG
GG
GG
GG
GG
GG
GG
GG
-You must set “Commercial Interface” to “On” to activate the below items.
Commercial Interface
OnCommercial Interface
Channel
OSD
Source
Volume
Pillow Speaker
Power Management
RCU and Local Key
Reset Commercial Interface
MENU
Exit
ENTER
Enter Select
FF GG
GG
GG
GG
GG
GG
GG
GG
GG
Commercial Interface
On
Virtual
Off
Off
Direct Tuning Access
ATSC Tune Mode
Power On Source
Power On Major Channel
Power On Miner Channel
Channel Hold
MENU
BackSelect
FF GG
FF GG
FF GG
2
0
FF GG
Channel
These TVs include a full commercial interface that allows your facility to customize the perfor-
mence to your specific needs. These settings are only accessible to the installer with the use of
the Master Remote(R130K2). Contact your RCA Commercial Distribution to obtain a master
remote.
You can access this menu by pressing MENU -> 9 -> 6 -> 3 -> 2 using the Master Remote.
Commercial Interface
OnCommercial Interface
Channel
OSD
Source
Volume
Pillow Speaker
Power Management
RCU and Local Key
Reset Commercial Interface
MENU
Exit
ENTER
Enter Select
FF GG
GG
GG
GG
GG
GG
GG
GG
GG
Commercial Interface
On
60S
On
Channel Banner
OSD Timer
Clear V-Chip
MENU
BackSelect
FF GG
FF GG
FF GG
- Channel Banner : If this function is off then channel banner will not appear when channel is changed.
- OSD Timer : Use this setting to configure the menu OSD time out.
- Clear V-Chip : This function can be used to Clear V-Chip password and settings.
OSD
- Direct Tuning Access : If this function is on, you can tune to channels even if the channels are not in the
channel list using the numeric keys. If this function is off, only channels in the channel list can be tuned.
-ATSC Tune Mode : This function sets the channel frequency type for Digital Channels to physical or virtual.
If the facility has a head end signal distribution system, set this to “physical”.
- Power On Source : Use this setting to configure the signal source of the TV when it is turned on.
- Power On Major/Minor Channel : Use this setting to configure the initial channel of the TV when it is
turned on.
Note: “Power On Source” should be set to “TV” to use this setting.
To tune to an analog channel, set minor channel to 0.
- Channel Hold : If this function is on then you cannot change channels.