Filter
Top Products
9
Setup and Connections
Step 3: Connect the G-LINK Cable
The G-LINK cable enables the GUIDE Plus+ Gold System (the on-screen
guide that lists what shows are on TV) to work with your VCR and/or
cable box.
Cable Box – If your TV is connected to a cable box and you don’t
connect the G-LINK cable, no channels will be listed in the on-screen
program guide.
VCR – If your TV is connected to a VCR and you don’t connect the G-LINK
cable, one-touch recording won’t work. The other features of the guide
will work properly.
How to Find the Remote Control Sensor
You have to place the G-LINK wands in front of the remote control
sensor on the VCR and/or cable box. Some cable boxes and VCRs have
the remote control sensor labeled on the unit. If the remote sensor isn’t
labeled on your VCR and/or cable box, you need to use the remote
control that came with the VCR and/or cable box to locate the sensor.
1. Turn off the VCR and/or cable box.
2. Hold the remote control (not the one that came with your TV, but
the one that came with the cable box and/or VCR to which you’re
connecting the G-LINK cable) so it is touching the front of the
component.
3. Slowly move the remote control across the front of the component
(VCR or cable box) while you press the power button on and off.
You must press and release the power button each time you move
the remote (holding down the button won’t work).
VCR
03
CHANNEL
Cable Box
4. When the component turns on, you’ve located the remote control
sensor.
5. Place the wands of the G-LINK cable underneath your VCR and/or
cable box (see instructions on right).
The G-LINK cable is used to send commands to
your VCR and/or cable box. You must remove the
DEMO PIN before you can connect the G-LINK
cable.
Placing the Wands Under the
VCR and/or Cable Box
Place the wands of the G-LINK cable
underneath your VCR and/or cable box.
Place them about one inch away from the
remote control sensor.
VCR
03
CHANNEL
SENSOR
SENSOR
Connect to G-LINK jack
on the back of the TV.
If you don't have a cable box, just coil the
cable of the extra G-LINK wand with a
twist tie and leave it behind the TV.
If you don't have a VCR, just coil
the cable of the extra G-LINK
wand with a twist tie and leave
it behind the TV.