Filter
Top Products
PROG RAMMI NG TH E REMOTE TO
CONTROL A LASER DISC PLAYER OR
DVD COMPONENT
The VCR2oDVD button on the remote is programmed to
control a VCR set to respond to the VCR2 button or an
RCA, ProScan, or GE laser disc player.
If you have an RCA DVD component, you can program the
VCR2oDVD button to operate it.
,
2.
Turn on the component.
Look up your component and its code number in the
code list on the right.
3. Press and hold the VCR2oDVD button on the remote.
4. Enter the three-digit code from the code list.
5. Release the VCR2oDVD button, and press PWR. If the
component turns off, setup is complete.
OPERATE THE COMPONENT
After you have set up your remote, see which button will
operate it.
1. Point the remote at the component, and press
VCR2oDVD. If it does not turn on, press VCR2eDVD
and then PWR.
2. You may want to experiment to see which buttons will
operate your component. Try pressing buttons, such as
CHAN up or down.
I CA, ProScan, and GE.Codes
VCR .............................................. 37
Laser Disc Player ........................ 37
DVD Player ................................. 78
I This remote may not operate all
models of the brands that are shown.
39