Filter
Top Products
For example, if you record a 30-minute program at the beginning
of the tape and you want to go to the end of that program to
begin another recording, you would:
1. Press INFO twice on the remote to display the time counter.
2. Press CLEAR to reset the time counter to 0:00:00.
3. Press FORWARD (FWD) to forward the tape until the time
counter reads 0:30:00.
,
,
Press STOR This is the approximate end of the program.
(You may want to press PLAY to verify.) Now, you can begin
recording at this spot.
Press INFO to remove the time counter from the screen and
return to the normal display mode.
0:30:00
Hours I
Minutes
Seconds
ON-SCREEN DISPLAYS
The INFO button shows the status of the VCR (STOP, PLAY,
RECORD, etc.), channel number, time counter, date, time, and
tape speed on the TV screen. The date and time must be set
before they can be displayed.
1. Press INFO to see all of the on-screen displays. These will
automatically time out after a few seconds
,
.
Press INFO again to have only the time counter remain on
the screen. This display doews not time out automatically.
Pressing INFO a third time disables the on-screen displays.
This feature prevents you from accidently recording on-
screen displays while copying tapes.
4. Press INFO to see all of the on-screen displays again.
1
2
Sl:op Ch 05 0:30:00
1_/18/97 Tue 01:30PM SLP
On-screendisp_y
_imes ou_
0:30:00
3
Time counter only
(does not time out)
On-screen display off
45