Filter
Top Products
PROGRAMMING THE REMOTE TO
CONTROL A DIGITAL SATELLITE
RECEIVER OR CABLE BOX
The remote is programmed to control an RCA, GE, or ProScan
digital satellite receiver.
If you have another brand of cable box or digital satellite
receiver with its own remote, you may be able to use the VCR's
remote to operate it.
1. Turn on the cable boxor digital satellite receiver.
2. Look up the brand and its code number(s) in the code list
on the right.
3. Press the SAToCABLE button on the remote.
.
5.
Enter the three digit code form the code list.
Release the SATeCABLE button and press PWR or CHAN up
or down to see if the cable box or receiver responds to the
remote commands.
OPERATE THE CABLE BOX OR DIGITAL
SATELLITE RECEIVER
After you have set up your remote, see which buttons will
operate your cable box or digital satellite receiver.
1. Point the remote at the box or digital receiver, and press
SAToCABLE and then PWR.
2. You may want to experiment to see which buttons will
operate your cable box or digital satellite receiver. Try pressing
buttons, such as CHAN up or down.
4O