Filter
Top Products
GO-TO SEARCH
The Go-To search feature enables the VCR to quickly locate a
counter reading anywhere on the tape. When the VCR locates
the counter reading, it will begin playback.
1. Press STOR
.
.
.
Press SEARCH on the remote until the GO-TO SEARCH menu
appears on the screen.
Press number buttons to enter the hour(s) and/or minutes of
the counter reading you want the VCR to "go to". Press
CLEAR on the remote to correct an entry.
Press FORWARD (FWD) to search forward or REVERSE(REV)
to search in reverse.
5. Press STOP to stop Go-To searching.
TRACKING
Your VCR has automatic tracking which removes the s{reaks or
snow from the picture. Automatic tracking is activated when you
insert a tape or turn on the VCR. Occasionally you may need to
manually adjust tracking, especially if the tape was recorded on a
different VCR. Just use the TRACKING buttons to remove the
streaks or snow. You can also use tracking when you pause a tape
to reduce jittering of the picture.
When you manually adjust the picture, automatic tracking is
turned off. To turn automatic tracking back on, press both
TRACKING buttons on the VCR at the same time, or eject the
tape and re-insert it.
Tracking only effects playback--not recording.
GOITO SEARCH
Current tape counter
2:17:25
Press REV or FWD
to go to -:--:00
Press SEARCH to exit
GO-TO SEARCH
Searching for
0:00:00...
Press SEARCH to exit
is
TIME COUNTER
The time counter shows the actual time it takes to record a
program or play back a segment of a recorded tape. It helps
locate the beginning or end of programs you taped. The time
counter resets to 0:00:00 whenever the tape is ejected from
the VCR.
44