Filter
Top Products
41
OTHER FEATURES
1. Insert a tape that has been previously recorded.
2. Press 4 to select the Mark an unmarked tape feature.
3. Position the tape where you want the marking to start
using PLAY, FWD , and REV buttons.
Set the tape to the
point at which you want
to start marking.
When the tape is ready,
press MENU to begin.
Press CLEAR to cancel
4. Press MENU to begin the marking process. The VCR will
play the tape until it finds six seconds (or more) of blank
tape or until the tape reaches the end. It will then rewind
the tape to the starting point you set and begin marking
the commercial segments.
MOVIE ADVANCE
MOVIE ADVANCE helps y ou locate certain parts of
prerecorded movies (rented or purchased). The feature works
in two ways: 1) you can go to the beginning of the movie or
2) you can skip from one preview to the next.
MOVIE ADVANCE w orks only on cassettes recorded in the
SP speed with the safety tab removed.
1. To select MOVIE ADVANCE, insert a tape with the
safety tab removed and press SEARCH. The following
menu appears.
What type of tape
is this?
1 Purchased/Rented Movie
2 Home Recording
3 Other
Press CLEAR to cancel
2. Press 1 if the tape is a purchased or rented movie, press 2
if it’s a recording made at home, or press 3 if it is
something else, you don’t know, or you do not want to
select MOVIE ADVANCE.
MOVIE ADVANCE is a trademark of SRT, Inc.
MOVIE ADVANCE works only on
cassettes recorded in the SP speed
with the safety tab removed.
When marking an unmarked tape
with COMMERCIAL ADVANCE, the
VCR plays the tape at normal speed,
so this process may take some time.