Filter
Top Products
Controlling an Auxiliary RCA Component
The remote that came packed with your VCR is also capable of controlling one compatible
RCA audio component, such as an AM/FM radio, CD player, tape player, or phonograph.
The remote must be programmed for the specific component it is to control. To program the
remote, use the code that corresponds to your component.
Program the Remote for an Auxiliary Component
1. Turn on the component.
2. Point the VCR remote at the component.
3. Hold the AUX button and press two number buttons to
enter the code for your component.
4. Release the buttons.
5. Press POWER on the remote. If the component turns
off, setup is complete.
Type of Auxiliary Audio Equipment and Code*
- ii
RCA
AM/FM CD I Tape Phono
03 07 t 06 05
* The remote may not be able to control every RCA model of audio
equipment listed.
Operate the Auxiliary Component
After you have set up your remote to control your component, test the buttons
to see which ones operate the component.
1. Point the remote at the component and press AUX.
2. If the component does not turn on in step 1, press AUX and then POWER.
3. Test the buttons on the remote to see which ones operate your component.
19