Filter
Top Products
Trouble Checks
Trouble
Will not record
Stereo or SAP sound not recorded
Rewind does not operate
VCR plus+ or timer recording not made
or wrong program recorded
Clock shows incorrect time or date
Here's what to try:
• Safety tab removed from cassette.
• Make sure the line indicator ("LI" or "L2") is turned off in VCR's display
panel for normal recording from the VCR's tuner. Press INPUT on remote to
turn off the line indicator.
• RECEPTION: STEREO/SAP/MONO feature must be set to STEREO to
record broadcast stereo. See page 31.
l • RECEPTION: STEREO/SAP/MONO feature must be set to SAP to record
SAP. See page 31.
1 • STEREO or SAP indicator not on. Station not broadcasting stereo or SAP.
• Tape already rewound.
• Wrong VCR plus+ code entered.
• Cable box setup not done or not done correctly. See page 33.
• Cable box was not turned on at time recording was to begin.
• Program entered incorrectly (wrong channel or times).
• Power interruption. Clock area in display panel will show :
• Check to see if time and date are correct -- including AM/PM.
• Program exceeded tape's length or tape was not rewound beforehand.
• VCR was not turned off at the time recording was to start.
• No tape in VCR or cassette's safety tab broken off.
• VCR ejects cassette when the end of the tape is reached during a timer
recording.
• Power interruption. Clock on the front panel will show -:- -.
• Clock was not set accurately (check AM/PM and date).
• Time counter display appears in VCR's display panel. Press DISPLAY on
remote.
VCR makes noise when stopped • VCR is removing tape from heads. This is normal. The head cylinder inside
the VCR will continue to rotate for a few minutes after you put the VCR in
the stop mode.
Will not AUTO-SEARCH active • Check antenna connections.
channels correctly • Check SIGNAL TYPE: GABLE/ANTENNA feature. See page 11.
Tape plays back in slow motion • Press PLAY,PAUSE on the VCR or PLAY on the remote to return to normal
playback.
.........................................................................................................................; Ca iecha eisover69 oniy sei te # .............
Cannot select channels over 69
CABLE/ANTENNA feature is set to GABLE. Details are on page 11.
47