Filter
Top Products
RCA DSS Satellite Receiver
Position RCA DSS ® receiver.
Position the receiver on top of tile VCR. You
may need to position it at different angles
before the VCR can control it. Make sure the
receiver does not cover the transmitting
window on top of the VCR.
Trans mitters
Satellite Receiver
. ... .... ..vG
[_ L._= ....................................................]
J
Remote Sensor
A.
Ko)l|ili||[_il(t]_'_=,ill
6
Basic hookup.
Use this ]lookup if your TV does not have
audio/video jacks.
1° Set the CH3 CH4 switch on back of
satellite receiver to either channel 3 or 4.
You will tune the VCR to this channel or its line
input (L1) to record from the receiver.
To watch the satellite receiver, turn off the VCR.
If you want to watch or record the signal from
your antenna, cable, or cable box, make sure the
satellite receiver is turned off.
2.
Set the CH3 CH4 switch on back of VCR
to either channel 3 or 4.
You will tune the TVto this channel and use the
-IV,VCR button to watch the VCR.
3.
4.
Connect as shown.
This connection may require additional
accessories not provided.
Plug in power cords of VCR, TV, and
receiver.
Caution: The unauthorized recording
of satellite broadcasts, television
programs, or other materials may
infringe the rights of others.
From From
Cable, Cable Box Satellite
orAntenna Dish
_ Back of Satellite Receiver _
H:: @ ..........@
mF.oM*m
OUTTOW
S-W_O
_) W0EO a *U_ L
@@
RF Coaxial Cable
75 to 75/300 Ohm \\\
Separator
OUT TO TV
..... ........................Back0ivcR "
III RF Coaxial Cable
_.. (supplied)
Back of TV