Filter
Top Products
Setup and installation — Installing the server
Installation & Getting Started Guide
21
through a transparent proxy server.
•InthePort field, the SRP Port, configured during the
firewall configuration process, is set to 3101, and is
typically not changed. This is an outbound-initiated
connection. Click Next to continue.
9. During your initial installation, click Test Connection.The
setup program will perform a test to ensure that the server can
connect to SRP Host.
If the test is successful, messages will confirm your connection.
From the DOS prompt, press Enter to continue. Click OK to
close the message and continue the installation.
If the test is not successful, you will see an error message. Note
the error code, and press Enter. Click OK in the dialog box to
close the error message.
10. In the SRP Authentication section, enter the SRP Identifier and
Authentication Key obtained from the label on the installation
Note
A transparent proxy does NOT modify requests or
responses through the proxy during proxy authentication
and identification, whereas a non-transparent proxy (where
the client specifies the hostname and port number of the
proxy) IS used to modify requests or responses through the
proxy. If you have a non-transparent proxy, the BlackBerry
Enterprise Server can be configured to access an internal
proxy address which is then translated externally to the
SRP Host on port 3101.
Note
If the SRP test is not successful, you will have to stop the
installation and correct the reason for the failure before you
can restart the installation. See the “Resolving Connection
Errors” section of this guide for a list of common errors and
suggestions for their resolution.