Filter
Top Products
23
System Reset
In the event that your PFP Controller appears to have a software problem, or adjustments
have been made so far out of range that the image is no longer on-screen or discernable,
you can reset it back to factory values. This sets ALL settings back to factory values, so any
adjustments made previously will be lost.
T
o reset your DR-300c PFP Controller, follow this procedure:
· Turn off the MAIN POWER switch on the back of the processor
· Hold down the DOWN ARROW button, and turn the MAIN POWER SWITCH back
on. Continue holding the down arrow button until the LED on the front panel blinks,
then release the down arrow button.
Once this is done, your processor has been completely reset to factory values. After resetting
the unit, Composite video will be the active source.
SYSTEM RESET is not on any of the menus; it must be performed using the instructions
above.
Picture Orientation
This will set the orientation of the image for your installation. If the Projector will be mounted
on a table, set this for Floor. If mounting it on the ceiling, select Ceiling. For two-mirror or
‘straight-shot’ rear-screen applications, select floor rear or ceiling rear as appropriate.
Lamp Hours displays the number of hours the lamp has been on. With the DR-300c, the lamp
life is around 1000 hours. This should be checked periodically to keep track of the lamp's
age, and when the lamp is around 1000 hours old, a new one should be installed to prevent
lamp failure, including implosion.
Lamp Hours