Filter
Top Products
1-1
SAFETY INSTRUCTIONS
Notice on Safety
This equipment is built in accordance with the requirements of the
international safety standards EN60950, UL 1950 and CSA C22.2
No.950, which are the safety standards of information technology
equipment including electrical business equipment.
These safety standards impose important requirements on the use
of safety critical components, materials and isolation, in order to
protect the user or operator against risk of electric shock and
energy hazard, and having access to live parts.
Safety standards also impose limits to the internal and external
temperature rises, radiation levels, mechanical stability and
strength, enclosure construction and protection against the risk of
fire.
Simulated single fault condition testing ensures the safety of the
equipment to the user even when the equipment's normal opera-
tion fails.
INSTALLATION INSTRUCTIONS
Before operating this equipment please read this manual thor-
oughly, and retain it for future reference.
Installation and preliminary adjustments should be per-
formed by qualified RUNCO personnel or by authorized
RUNCO service dealers.
OWNER’S RECORD
The part number and serial number are located at the back side of
the projector. Record these numbers in the spaces provided below.
Refer to them whenever you call upon your RUNCO dealer
regarding this product.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
!
CAUTION: TO REDUCE THE RISK OF ELECTRICAL SHOCK,
DO NOT REMOVE COVER (OR BACK)
NO USER-SERVICABLE PARTS INSIDE
REFER SERVICING TO QUALIFIED PERSONNEL
SER. NUMBER:
DEALER:
The lighting flash with an arrowhead within a
triangle is intended to tell the user that parts
inside this product may cause a risk of electrical
shock to persons.
!
The exclamation point whithin a triangle is in-
tended to tell the user that important operating
and/or servicing instructions are included in the
technical documentation for this e
q
ui
p
ment.
FEDERAL COMMUNICATION COMMISSION (FCC
STATEMENT)
This equipment has been tested and found to comply with the lim-
its of a class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful inter-
ference to radio communications. Operation of this equipment in
a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own
expense.
Note:
The use of shielded cables is required to comply within the limits
of Part 15 of FCC rules and EN55022
*All the safety and operating instructions should be read
before using this unit.
*The safety and operating instructions manual should be
retained for future reference.
*All warnings on the equipment and in the documentation
manuals should be adhered to.
*All instructions for operating and use of this equipment must
be followed precisely.
On Safety
1. This product should be operated from an AC power source.
This projector may be connected to an IT-power system.
Operating AC power voltage of the projector:
DTV-940/943: 110/120 VAC, 50/60 Hz; unless otherwise specified.
Consult your dealer to switch over from 230Vac to 120Vac or from
120Vac to 230Vac.
If you are not sure of the type of AC power available, consult your
dealer or local power company.
2. This product is equipped with a 3-wire grounding plug, a plug
having a third (grounding) pin. This plug will only fit into a
grounding-type power outlet. This is a safety feature. If you are
unable to insert the plug into the outlet, contact your electrician to
replace your obsolete outlet. Do not defeat the purpose of the
grounding-type plug.
WARNING FOR THE CUSTOMERS: THIS APPARATUS
MUST BE GROUNDED (EARTHED) via the supplied 3 conduc-
tor AC power cable.
(If the supplied power cable is not the correct one, consult your
dealer.)