Runco Q-650i Home Theater Screen User Manual


 
Operation
46 Q-650i Series Installation/Operation Manual
PRE
L
IMINAR
Y
Main The Q-650i Main Menu, shown in Figure 4-2, provides access to the most
commonly-used projector functions.
Figure 4-2. Q-650i Main Menu
Aspect Ratio: To change the aspect ratio (size and shape) of the projected image, press
or to highlight Aspect Ratio. Use the or buttons to select the appropriate
aspect ratio for your screen size, installed lens configuration and the type of program
material being viewed, then press ENTER; refer to Table 4-2.
1. For best results, Runco recommends that you set
ConstantContrast to Off before adjusting Brightness, Contrast and
other image quality settings in this menu (refer to
ConstantContrast on page 58). After you have completed the
initial calibration, set ConstantContrast to On if desired.
2. Image controls only operate on the active source. To adjust the PIP
source, switch to the PIP source (thereby making it the active
source), adjust the controls and then switch back.
Note