Filter
Top Products
Operation
Vistage™ Series Flat-Panel Display Installation/Operation Manual 47
PRE
L
IMINAR
Y
• Splash Timer: When you turn on the V-50HD/V-63HD, it projects a welcome screen
with the Runco and ISF logos, along with the personalized information you enter as
described above. Select Splash Timer from the Splash Configure menu to set the
amount of time for which this screen appears. The range is from 5 to 60 seconds, in
one-second increments. Press or to set the timer, then press MENU.
• Splash Enable: When you have finished customizing the splash screen, select Splash
Enable from the Splash Configure menu. Then, select On and press ENTER.
OSD Position: To adjust the position of the OSD, select OSD Position from the
Calibration menu and press ENTER.
Press or to select “Hor.” or “Ver.” Then, press or to change the position.
ServiceUse the Service menu to access advanced display configuration settings. This menu
should be used by ISF-certified technicians only.
Test Video: Select Test Video from the Service Menu to access the internal test patterns
on the DHD Controller. Table 4-3 lists the available test patterns and describes their
suggested usage.
Service
Test Video
Input Names
Display Device
Network
Color Space
Miscellaneous
Sync Threshold
HDMI
Front Panel Brightness
Auto Power Off
Standby Mode
System Reset
You must enter a passcode to access the Service menu.
Table 4-3. Test Patterns and Their Suggested Usage
Pattern Suggested Usage
Color Bars 1
Use this pattern when making
color saturation and tint
adjustments.
Color Bars 2
Use this pattern when making
color saturation and tint
adjustments.
Focus
Typically not used with flat-panel
displays.
Note