Filter
Top Products
Operation
Vistage™ Series Flat-Panel Display Installation/Operation Manual 55
PRE
L
IMINAR
Y
Front Panel Brightness: Select Front Panel Brightness from the Service menu to adjust
the brightness of the front-panel LED status indicator.
• Logo LED: Select Logo LED from the Front Panel Brightness menu to adjust the
brightness of the blue LED segment. The range is from 0 (off) to 31.
• Standby LED: Select Standby LED from the Front Panel Brightness menu to change
the behavior of the yellow LED segment. When set to ON, the LED lights amber when
the system is in standby mode; otherwise, it is off. When set to OFF, the LED is always
off.
Auto Power Off: Select Auto Power Off from the Service menu to have the
V-50HD/V-63HD turn itself off after a period of inactivity (no source signal present).
•Enable: By default, Auto Power Off is disabled. To enable it, select Enable from the
Auto Power Off sub-menu and set it to On.
•Hours: The default time-out period is eight (8) hours; the range is from 1 to 24 hours.
Standby Mode: Select Standby Mode from the Service menu to control the DHD
Controller’s power management feature.
•Choose Low Power (the default setting) to have the DHD Controller shut down
completely when it is turned off. This conserves power but increases the amount of
time required by the DHD Controller to start up when it is turned on.
• Fast Startup is a “quick-start” mode that keeps the DHD Controller running when it is
turned off even though it appears to be in standby mode. This allows for much quicker
startup times but consumes more power.
System Reset: To reset ALL controller settings (including image settings) back to their
factory defaults, choose System Reset from the Service menu.
A confirmation message appears. Select Yes to continue with the reset or select No to
cancel.
During a firmware upgrade, this LED lights at full brightness
regardless of the Logo LED setting.
During a firmware upgrade, this LED lights at full brightness
regardless of the Standby LED setting.
This action is not undoable. Proceed with caution! Before you
perform a System Reset, save your “Custom” Memory Presets
(page 38) and ISF Day/Night Memory Presets (page 44).
Logo LED Segment (Blue)
Standby LED Segment (Yellow)
Note
Note
Caution