Filter
Top Products
58
English
Other Information
Issues
Solutions and Explanations
Others
Purple/green rolling horizontal bars and
buzzing noise from the TV speakers with
Component cable connection.
Remove the left and right audio connections from the set-top-box. If the buzzing stops, this indicates •
that the set-top-box has a grounding issue. Replace the Component video cables with an HDMI
connection.
The picture will not display in full screen. HD channels will have black bars on either side of the screen when displaying upscaled SD (4:3) •
contents.
Black bars on Top & Bottom will be shown on movies that have aspect ratios different from your TV.•
Adjust picture size option on your external device or TV to full screen.•
The remote control does not work. Replace the remote control batteries with correct polarity (+/–).•
Clean the transmission window located on the top of the remote.•
Try pointing the remote directly at the TV from 5~6 feet away.•
The cable/set top box remote control
does not turn the TV on or off, or adjust
the volume.
Program the Cable/Sat remote control to operate the TV. Refer to Cable/Sat user manual for •
SAMSUNG TV code.
A “Mode Not Supported” message
appears.
Check the supported resolution of the TV and adjust the external device’s output resolution •
accordingly. Refer to resolution settings in this manual. (P. 10)
Caption on TV menu is greyed out. Caption• can not be selected in the TV menu when connected via HDMI or Component.
Caption• must be activated on the external device.
There is a plastic smell from the TV. This smell is normal and will dissipate over time.•
TV Signal information is unavailable in
the Self Diagnosis Test menu.
This function is only available with digital channels from an Antenna / RF/Coax connection. •
(P. 26)
TV is tilted to right or left side. Remove the stand base from TV and reassemble it.•
The Channel menu is greyed out
(unavailable).
The • Channel menu is only available when the TV source is selected.
Your settings are lost after 30 minutes or
every time TV is turned off.
If TV is in the • Store Demo mode, it will reset audio and picture settings every 30 minutes. Please
change from Store Demo mode to Home Use mode in the Plug & Play procedure. Press the
SOURCE button to select TV mode, go to MENU → Setup → Plug & Play → ENTERE.
You have intermittent loss of audio or
video.
Check the cable connections and reconnect them.•
Loss of audio or video can be caused by using overly rigid or thick cables. Make sure the cables are •
flexible enough for long term use. mounting the TV to the wall, we recommend using cables with 90
degree connectors.
The PIP menu is not available. PIP functionality is only available when you are using a HDMI, PC or components source.•
You see small particles when you look
closely at the edge of the frame of the TV.
This is part of the product’s design and is not a defect.•
POP (TV’s internal banner ad) appears on
the screen.
Select • Home Use under Plug & Play mode.
For details, refer to Plug & Play (Initial Setup). (P. 7)
This TFT LCD panel uses a panel consisting of sub pixels which require sophisticated technology to produce. However,
✎
there may be a few bright or dark pixels on the screen. These pixels will have no impact on the performance of the
product.
Storage and Maintenance ¦
Do not spray water or a cleaning agent directly onto the
product. Any liquid that goes into the product may cause a
failure, re, or electric shock.
Clean the product with a soft cloth dapped in a small
amount of water.
BN68-02584A_Eng.indb 58 2010-08-31 �� 9:17:12