Filter
Top Products
INSTALLATION
English - 13
Connecting VHF and UHF Antennas
If your antenna has a set of leads that look like this,
see “Antennas with 300-ohm Flat Twin Leads”
below.
If your antenna has one lead that looks like this,
see “Antennas with 75-ohm Round Leads” on page
14.
If you have two antennas, see “Separate VHF and
UHF Antennas” on page 14.
Antennas with 300-ohm Flat Twin Leads
If you are using an off-air antenna (such as a roof antenna or “rabbit ears”) that has
300-ohm twin flat leads, follow the directions below.
1
Place the wires from the
twin leads under the screws
on the 300-75 ohm adapter
(not supplied). Use a
screwdriver to tighten the
screws.
2
Plug the adapter into the
“ANT 1 IN (AIR)” terminal on
the rear panel.
INSTALLATION
Chapter Two
AA68_03783B_02_LEng 9/12/06 5:37 PM Page 13