Filter
Top Products
INSTALLATION
English - 17
Connecting a VCR
These instructions assume that you have already connected your TV to an air or a cable
TV system (according to the instructions on pages 13~16).
• Please be sure to match the color coded input terminals and cable jacks.
• Also, you can connect to “AV IN 2” on the side panel of TV.
TV Rear Panel
From Cable
Coaxial
Cable
From Antenna
Video Cable
Audio Cable
VCR Rear Panel
1
2
3
1
Connect a coaxial cable between the “ANT
1 IN (AIR)” (or “ANT 2 IN (CABLE)”)
terminal on the TV and the antenna out
terminal on the VCR.
A coaxial cable is usually included with a
VCR. (If not, check your local electronics
store).
2
Connect a set of audio cables between the
“AV IN 1 (R, L)” jacks on the TV and AUDIO
OUT jacks on the VCR.
If you have a mono VCR, connect L (mono)
to VCR audio out using only one audio
cable.
3
Connect a video cable between the “AV IN
1 (VIDEO)” jack on the TV and the VIDEO
OUT jack on the VCR.
Refer to your VCR’s instructions for more
information about how to view your VCR
tape.
AA68_03783B_02_LEng 9/12/06 5:37 PM Page 17