Filter
Top Products
Setting the Date and Time
Your COMBI VISION contains a 24-hour clock and calendar used
to:
◆ Preset the VCR to record up to six programmes
automatically over a period of one month
◆ Switch the set on or off automatically at a specific time
You must set the date and time when:
◆ You purchase the COMBI VISION
◆ The power supply is switched or cut off
1 Press MENU ( ) on the remote control.
Result
: The television menu is displayed.
2 Select the option by pressing P ▲ or ▼ the appropriate number of
times, followed by the + button.
Result
: The current date and time are displayed.
3 Enter the hour and then the minutes by pressing the numeric buttons.
➢ When a time is entered, all single digits must be preceded by a
zero.
Example: 3:07 p.m.
Enter 15:0
7
4 To select the date, press P ▼.
5 Press the numeric, + or - buttons to enter the:
◆ Day
◆ Month
◆ Year
Result
: The day of the week is displayed automatically next to the date.
➢ When a date is entered, all single digits must be preceded by a
zero.
Example
: 6th April 2000
Enter 06/0
4/00
6 When you are satisfied with your settings, press MENU ( ) twice to
return to normal viewing.
➢ If you do not press a button for more than 30 seconds, the
display disappears automatically.
If you make a mistake when entering the date or time,
press the
-
button one or more times to return to the
incorrect figure and enter the correct one.
You cannot set the date and time during a programmed
recording.
12
MENU
PICTURE
TUNE
SETUP
--:--
ADJUST SELECT EXIT
TIME : 15:07
DATE : 06/04/00 THU
ADJUST SELECT EXIT
GB
V.MENU MUTE
DISPLAY P.STD
MENU
P
P
Pre.
02255A_eng1_mono 6/29/04 10:42 AM Page 12