Filter
Top Products
DCB-9401V
GB-19
GB
DCB-9401V
GB-18
DIGITAL CABLE RECEIVER
OPERATING THE RECEIVER OPERATING THE RECEIVER
1. Installation
This menu consists of 3 sub-menus:
Scan, Manual Scanning and Reset to Factory Defaults.
● Select “Installation” in the main menu mode to select the
sub menu.
● Enter the PIN Code.
If you have not entered your own PIN Code then the
PIN Code 0000 applies, which was set at the factory.
1.1 Scan
To tune-in new channels and weak signals, the STB has been
provided with “Scan” where the channel data can be entered
by the user. After selecting the “Scan” from the Installation
Menu, the following screen will be displayed:
● You can specify the target frequency band and scan channels
within the specified frequency band.
Input the frequency of the Channel you want to find.
Frequency F1: Select a start frequency to start the scan
operation.
Frequency F2: Select an end frequency to end the scan operation.
● Input the symbol rate of Channel you want to find.
● Select the Modulation of the Channel you want to find.
You can select the value of 16, 32, 64, 128, 256 QAM, or Automatic.
● After select option, press OK key to start the scan process.
1.2 Manual Scanning
To tune-in new channels and weak signals, the STB has
been provided with “Manual Scanning” where the channel
data can be entered by the user. After selecting the “Manual
Scanning” from the Installation Menu, the following screen will
be displayed:
● Input the frequency of the Channel you want to find.
● Input the symbol rate of Channel you want to find.
● Select the Modulation of the Channel you want to find.
You can select the value of 16, 32, 64, 128, 256, Automatic.
● After select option, press OK key to start the scan process.
1.3 Reset to Factory Defaults
This to restore the factory set values in case the user has
encountered some problems after changing any values
of channel data and others which may be in error.
At the request window, if you press the OK key, the receiver
will be reset to factory default settings automatically.
NNoottee : This cause your previous settings to be deleted!
2. Channel Organising
The “Channel Organising” menu has three functions:
The “Channel Organising” menu is used to delete
all channels, add or remove favorite channels and
move favorite channels as you want.
● Select the “Channel Organising” and enter the PIN Code.
If you have not entered your own PIN Code 0000 applies,
which was set at the factory.
2.1 Delete All Channels
At the request window, press the OK key to delete
all channels and press the EXIT to exit.
MF68-00354A(REV1.2)_GB 6/30/05 1:48 PM Page 18