Filter
Top Products
DCB-9401V
DCB-9401V
GB-29GB-28
DIGITAL CABLE RECEIVER
GB
Power supply
Type : SMPS
Input Voltage : AC 100 - 240V~, 50/60 Hz
Fuse rating : 250 V/T1.6 AH
Power Consumption : Max. 10W
Stand by : 7W
Tuner & Demodulator
Input Frequency : VHF,UHF BAND(50~870 MHz)
DEMODULATION : QAM DVB-C
SYMBOL RATE : MAX 7 Msps
Constellation : 16, 32, 64, 128, 256 QAM
CABLE OUT : LOOPOUT FOR ANALOG RECEIVER
Video decoder
System decoding : MPEG 2 ISO/IEC 13818
(Transport Stream)
Profile and level : MPEG 2 MP@ML (4:2:2)
Data rate : 1~ 15 Mb/s
Video formats : 4:3 (normal) & 16:9 (widescreen)
Picture resolution : 720(H) x 576(V) x 50 fields/sec
Audio Decoder
System decoding : MPEG 1 ISO/IEC 11172~3 layer I & II
Audio mode : single channel, dual channel, stereo,
joint stereo
Sampling frequency : 32, 44.1, 48 KHz
NNoottee : The specification of the STB may be changed without notice in advance.
TECHNICAL SPECIFICATIONSTROUBLESHOOTING
Problem Possible cause Solution of the problem
No display LED on Power cord Power cord plug in correctly
the front panel; not plugged in correctly
No power supply
No pictures on the screen Receiver in Standby mode; Set receiver to “On”;
SCART not connected tightly Check connection and correct;
to video output of television;
incorrect channel or video Check channel and video output and
output selected on television correct (TV instruction manual)
No sound Scart cable connected Check connection and correct;
incorrectly;
Volume level = 0; Increase volume on television set;
Muting active Press the MUTE key
Remote Control does not Batteries dead or inserted Point remote control towards the
operate directly incorrectly Receiver.
Replace batteries or insert correctly
Poor picture quality Signal strength too low Check the signal strength in
the “Installation” menu, correct
alignment of your signal cable
On-Screen Error Message Signal cable not connected Check connection and correct;
“Searching for signal” or not tight;
incorrect position of the Check position and correct,
signal; Check the signal strength in
the “Installation” menu
On-Screen Error Message Receiver not yet set Scanning of in “Installation” menu
“No channels are stored.”
On-Screen Error Messages: Smartcard: (depending on models)
“Channel is not entitled. - not plugged in correctly; Check the Smartcard.
Please check the card.”; - not plugged in. “Insert the Smartcard.”
“Please insert the
Smartcard”.
On-Screen Error Message No access to this channel Check that you subscribe to this channel.
“No access” If the STB has been switched off for a
longer period of time, turn on the STB,
select any channel, and wait for
authorization for up to 60 minutes.
The device, packaging material (e.g. Styrofoam) and the batteries must never be disposed
of with household refuse.
Please obtain appropriate information about the regulations in your community, and dispose
of all refuse in accordance with regulations at the separate locations provided.
DISPOSAL
MF68-00354A(REV1.2)_GB 6/30/05 1:48 PM Page 28