Filter
Top Products
ENG-10
SETUP
Rear Panel
1. AUDIO OUT JACKS
Use audio cables to connect to the Audio input jacks of
your television or audio/video receiver
2. VIDEO OUT JACK
- Use a video cable to connect to the Video input jack on
your television.
3. COMPONENT VIDEO OUT JACKS
- Use these jacks if you have a TV with Component
Video in jacks. These jacks provide P
R
, P
B
and Y video.
- If
P-SCAN (480p)
is set to “ON” in Video Output of
the Setup Menu, progressive scan mode will work.
- If
I-SCAN (480i)
is set to “ON” in Video Output of the
Setup Menu, interlaced scan mode will work.
4. DIGITAL AUDIO OUT JACKS
- Use a coaxial digital cable to connect to a compatible
Dolby Digital receiver.
- Use a coaxial digital cable to connect to an A/V
Amplifier that contains a Dolby Digital, MPEG2 or DTS
decoder.
Note
-
Consult your TV User’s Manual to find out if your TV supports Progressive Scan (P-SCAN).
If Progressive Scan is supported, follow the TV User’s Manual regarding Progressive Scan settings in the
TV’s menu system.
- See pages 49 ~ 50 to get more information on how to use the setup menu.
1 2
3
4
DVD_P181_XAA1.1 2/12/08 3:56 PM Page 10