Filter
Top Products
English - 20
Coarse 1056
Fine 0
Move Enter Return
Image Lock
Setting the PC
Coarse and Fine Tuning of the Image (Image Lock):
The purpose of picture quality adjustment is to remove or reduce
picture noise. If the noise is not removed by Fine-tuning alone, then
adjust the frequency as best as possible (coarse) and Fine-tune
again. After the noise has been reduced, re-adjust the picture so
that it is aligned on the center of screen.
1. Preset: Press the SOURCE button to select PC mode.
2. Press the MENU button to display the menu.
Press the ▲ or ▼ button to select “Setup”, then press the
ENTER button.
3. Press the ▲ or ▼ button to select “PC”, then press the
ENTER button.
4. Press the ENTER button to select “Image Lock”.
5. Press the ▲ or ▼ button to select “Coarse” or “Fine”, then press the
ENTER button.
6. Press the ◄ or ► button to adjust the screen quality.
Press the
ENTER button.
7. Press the EXIT button to exit.
Changing the Image Position (Position):
Adjust the PC’s screen positioning if it does not fit the TV screen.
1. Follow the “Coarse and Fine Tuning of the Image (Image Lock)”
instructions number 1 to 3.
2. Press the ▲ or ▼ button to select “Position”, then press the
ENTER button.
3. Press the ▲ or ▼ button to adjusting the Vertical-Position.
Press the ◄ or ► button to adjust the Horizontal-Position.
Press the ENTER button.
4. Press the EXIT button to exit.
Initializing the Image Settings (Image Reset):
You can replace all image settings with the factory default values.
1. Follow the “Coarse and Fine Tuning of the Image (Image Lock)”
instructions number 1 to 3.
2. Press the ▲ or ▼ button to select “Image Reset”, then press the
ENTER button.
3. Press the EXIT button to exit.
Adjusting the PC Screen Automatically (Auto Adjustment):
Auto adjustment allows the PC screen of set to self-adjust to the
incoming PC video signal. The values of fine, coarse and position
are adjusted automatically.
1. Follow the “Coarse and Fine Tuning of the Image (Image Lock)”
instructions number 1 to 3.
2. Press the ▲ or ▼ button to select “Auto Adjustment”, then press the
ENTER button.
3. Press the EXIT button to exit.
Adjust Enter Return
Position
Move Enter Return
Image Lock
Position
Image Reset
Auto Adjustment
PC
Move Enter Return
Image Lock
Position
Image Reset
Auto Adjustment
PC
BN68-1177N-Eng-0824.indd 20 2007-08-24 �� 4:04:51