Filter
Top Products
English-23
1.3 Manual Scanning
To tune-in new channels and weak signals, the TV has been provided with the option
“Manual Scanning” where the channel data can be entered by the user. After selecting the
“Manual Scanning” from the Installation Menu, the following screen will be displayed:
• Select the Channel Number.
You can select the specified channel you want to find.
The followings are defined as a default, but optionally you can choose it.
Signal Status bar shows you if it is valid.
• Input the frequency of the channel you want to find.
• Select the bandwidth. You can select the value of "6", "7" or "8" MHz.
• Select the Guard Interval Mode.
You can select the value of "AUTO", "1/32", "1/16", "1/8", or "1/4".
• Select the FFT (Fast Fourier Transform) Mode.
One of the values-"AUOT", "2 K", and "8 K"- will be selected automatically.
You may change the set value as your preference.
• After selecting option, press the ENTER/OK button to start the scanning process.
1.4 Reset to Factory Defaults
This is to restore the factory set values in case the user has encountered some problems
after changing any values of channel data and others which may be in error. At the request
window, if you press the ENTER/OK button, the TV will be reset to factory default settings
automatically.
This causes your previous settings to be deleted!
2. Channel Organising
The “Channel Organising” menu has four functions:
The “Channel Organising” menu is used to delete the Frequencies and Channels or
Move&Edit Channel as you want.
• Enter the PIN Code.
If you have not entered your own PIN Code 0000 applies,
which was set at the factory.
Once you have entered PIN Code, you do not have to input the code again
unless you turn the TV power off.
BN68-01007R-00Eng.indd 23BN68-01007R-00Eng.indd 23 2006-08-08 9:24:172006-08-08 9:24:17