Filter
Top Products
English - 129
Continued...
Possible Solution
Check if the current mode for DTV and STB is set to
analog by mistake. For AVHDD, check if the played
content reaches to the end. (Select the item from
the content list again.) For DVHS, check if a D-VHS
tape is being used. If the camcorder supports the
DV format, no picture will be displayed on the screen.
This message appears when the D-Net function is
being initialized.
Retry after a short wait to use the D-Net function.
This message appears when the number of currently
connected D-Net devices exceeds 10.
Retry after disconnecting unnecessary devices.
This message appears when the recordable device is
not on the network when you try to make a
recording using a D-Net device.
Retry after connecting a recordable device (DVHS,
AVHDD).
The message appears informing you that you cannot
change the channels or change the input source using
the remote control because a recording is in progress
through D-Net.
Retry after stopping the current recording through
D-Net.
This message appears when the selected function is
not supported by the relevant device or the relevant
device cannot execute the selected function.
Most STBs, DTVs and camcorders do not support
the power on/off command. This message may
appear when you issue the power command
for these devices. This message also appears when
the command is supported but the relevant device
cannot follow the command.
Retry after checking the current mode of the relevant
device.
This message appears when the user presses the
RECORD button in analog mode.
D-Net only supports recording for digital.
This message appears when the selected device does
not support the MPEG format.
At present, D-Net supports MPEG TS only.
Problem
No picture on the screen after
selecting a device
“Initializing D-Net” message
appears.
“Exceeds the limit of device
numbers.” message appears.
“Recordable device is not
connected” message appears.
“Not available while recording”
message appears
“The connected device is
unavailable to perform this
function for temporary problems.”
message appears.
D-Net cannot record video from analog
channels from connected external
equipment.
“Not available format is selected.”
message appears.
BP68-00587A-00Eng(114~129) 4/28/06 7:38 PM Page 129