Filter
Top Products
Operation
English - 34
Customizing Your Remote Control
After it has been set up properly, your remote control can operate in five different modes: TV, VCR,
Cable, DVD, or Set-Top Box. Pressing the corresponding button on the remote control allows you to
switch between these modes, and control whichever piece of equipment you choose.
NOTE
• The remote control might not be compatible with all DVD Players, VCRs, Cable boxes,
and Set-Top Boxes.
Setting Up the Remote to Operate Your VCR
1
Turn off your VCR.
2
Press the VCR button on your TV’s remote control.
3
Press the SET button on your TV's remote control.
4
Using the number buttons on your remote control, enter three
digits of the VCR code listed on page 38 of this manual for your
brand of VCR. Make sure you enter three digits of the code, even
if the first digit is a “0”. (If more than one code is listed, try the
first one.)
5
Press the POWER button on the remote control. Your VCR should
turn on if your remote is set up correctly.
If your VCR does not turn on after set-up, repeat steps 2, 3 and 4,
but try one of the other codes listed for your brand of VCR.
If no other codes are listed, try each VCR code, 000 through 080.
Note on Using Remote Control Modes: VCR
When your remote control is in “VCR” mode, the volume buttons still
control your TV’s volume.
BP68-00586A-00Eng(026~047) 2/13/06 2:18 PM Page 34