Filter
Top Products
INSTALLATION
English - 18
Connecting a Second VCR to Record from the TV
Your TV can send out signals of its picture and sound to be recorded by a second VCR.
To do this, connect your second VCR as follows:
1
Connect a set of audio cables between the
“AV OUT (L, R)” jacks on the TV and the AUDIO
IN jacks on the VCR.
(The VCR input jacks might be either on the
front or rear of the VCR.)
2
Connect a video cable between the “AV OUT
(VIDEO)” jack on the TV and the VIDEO IN jack
on the VCR.
Refer to your VCR’s instructions for more
information about how to record using this kind
of connection.
TV Rear Panel
From Cable
Video Cable
Audio Cable
VCR Rear Panel
1
2
Connecting a Camcorder
The side panel jacks on your TV make it easy to connect a Camcorder to your TV. They
allow you to view the Camcorder tapes without using a VCR.
• Please be sure to match the color coded input terminals and cable jacks.
1
Locate the A/V output jacks on the Camcorder.
They are usually found on the side or rear of
the Camcorder.
2
Connect a set of audio cables between the
“AV IN 2 (L, R)” jacks on the TV and the AUDIO
OUT jacks on the Camcorder.
If you have mono Camcorder, connect L(mono)
to Camcorder audio out using only one audio
cable.
3
Connect a video or S-video cable between the
“AV IN 2 (VIDEO)” (or “S-VIDEO”) jack on the
TV and the VIDEO OUT jacks on the
Camcorder.
The audio-video cables shown here are usually included with a Camcorder. (If not, check your local
electronics store.) If your Camcorder is stereo, you need to connect a set of two cables.
• This figure shows the Standard connector-jack panel. The actual configuration for your TV may be
different.
2
TV Side Panel
S-Video Cable
Video Cable
OR
Audio Cable
Camcorder
3
3
AA68_03783A_00Eng 3/17/06 4:32 PM Page 18