Filter
Top Products
74_ main menu
main menu
Preset Setting
A preset is a set of specific target points of a PTZ camera, and up to 127 presets per a camera can be stored.
1. In PTZ Control mode, use the direction buttons to adjust the camera in a desired direction.
2. Select the <Save> key.
The virtual keyboard for inputting the preset will appear.
`
Refer to “Using Virtual Keyboard”. (Page 36)
•Save : You can save the preset settings.
•Rename : You can change the settings of the existing presets.
•Delete : Deletes the selected preset.
•Delete All : Deletes all existing presets.
M
`
If you replace the camera of the channel that stores the preset list with a new one, you should reset the preset
accordingly.
3. Press <OK>.
The preset will be saved as a name that you entered.
Camera Setting
A PTZ camera has its own menu system. Optimize the PTZ camera according to the DVR.
1. Connect the PTZ camera to the DVR and run the PTZ
camera again to display the camera’s protocol setting
window.
2. Check the protocol ID of the camera.
`
In “Device > Setting the PTZ”, enter the PTZ camera ID in the
ID input box of the channel that is connected to the PTZ camera.
(Page 47)
3. Select <Camera Setup> in the PTZ Control menu.
The camera-specific menu appears.
` You can configure the settings of only those cameras that support
the protocols of Samsung, Pelco D/P, AD and Panasonic.
` If you are setting Auto Pan or Pattern in the camera menu, press
and hold the appropriate button for a certain time so that the button
operation can be different from that in normal PTZ setting.
2012-01-01 01:10:252012-01-01 01:10:25
**
MAIN MENU
**
CAMERA SET...
VIDEO SET...
PRESET...
ZONE SET...
AUTO SET...
ALARM SET...
OTHER SET...
CLOCK SET...
SYSTEM INFO...
Camera Setup
Exit
2012-01-01 01:10:252012-01-01 01:10:25
SAMSUNG PROTOCOL
ADDR 0
TYPE RS-485,HALF
BAUD 9600
LENS OK!
TILT OK!
PAN OK!