Filter
Top Products
SHR-2040/2041/2042 USER’S MANUAL
2-9
8. Check the connector, wiring, and cable fixing condition inside the product and close the
cover.
9. Tighten cover-fixing screws. (5 points on both sides and 1 point in the back side)
✻ You can apply 2 HDDs to each BRACKET-HDD as shown in the figure.
Caution
Caution
For HDD addition, please select the same HDD with the existing HDD fixed to the product as
far as possible.
- SHR-2040 : 1 at Primary Slot and 1 at Secondary Slot respectively
- SHR-2041 : 2 at Primary Slot and 2 at Secondary Slot respectively
- SHR-2042 : 2 at Primary Slot and 1 at Secondary Slot(The internal CD-RW is connected to
the secondary master.) respectively
Both HDDs attached to Primary Slot and Secondary Slot should be set to Master and Slave
respectively. Refer to User’s Manual for Master or Slave Jumper Setting.
In the event of only one HDD installation, it shall be inserted into the Primary slot.
Note
Note
Refer to Appendix 2 to see which HDD specifications are supplied.
SHR-2040/2041/2042-ENG-1 2005.6.29 4:58 PM Page 2-9