Filter
Top Products
16
ENG
The Auto Store function makes channel storage easier and faster
than manual store.
This Auto Store can memorise on-air channels from present
channels in numerical order.
1 If the TV is in stand-by mode (red light on), press the “POWER” button on the
remote control. Press the “MENU” button and press CH ▲ or CH ▼ button to
place on the “Setup” option.
2 Press VOL+ or VOL– buttons then the “Setup” menu is displayed and
press CH ▲ or CH ▼ buttons to place on the “Auto store” option.
3 Press VOL+ or VOL– buttons and press CH ▲ or CH ▼ buttons to place
on the area where you live.
☛
If you want start Auto store program number 20, before pressing
MENU, select program number 19 by pressing CH▲ or CH▼ buttons
or direct channel selection buttons (0~9).
4 Press the VOL+ or VOL–buttons.
◆ The Television scans the VHF L, VHF H and UHF frequency bands in
turn and stores the available channels:
◆ The progress of the scan is indicated by a horizontal bar & percentage.
◆ The number of the channel currently being searched for and the
frequency being scanned are displayed.
◆ When channel broadcasted is memorised, horizontal bar turns yellow.
◆ After every channel broadcasted is memorised, “Sort” menu is
displayed.
◆ At this point you can view real picture through Sub picture.
5 Press “MENU” button repeatedly until the menus disappear.
➣
Programme mode (P)
◆ When completing Auto Store, the broadcasting stations
in your area have been assigned to position number
from P00 to max P99. You can select a channel by
entering the position number in this mode.
Real Channel mode (C)
◆ You can select a channel by the assigned number to
each air broadcasting station in this mode.
CATV channel mode (S)
◆ You can select a channel by entering the assigned
number for each cable channel in this mode.
A
Menu
Picture
Sound
Time
Setup
Function
PinP
Sel. Enter
Setup
Auto store
Manual store
Channel skip
Fine tune
Sort
Sel. Enter
Asia/W. Europe
CIS/E. Europe
China
Hongkong/UK
Australia
NZ/Indonesia
South Africa
America
Sel. Set
* Searching *
Exit
P27
450MHz
50%
S.STD SURROUND S.MODE
P.STD MENU
P.MENU
CH
VOLVOL
SWAP CH SCAN STILL
ROTATEMULTIPinP
ON
Tuning Procedure (Auto store)
11318A#2 8/17/05 12:42 PM Page 16