Filter
Top Products
13
ENG
Plug & Play Feature
When the television is initially powered ON, three basic customer
settings proceed automatically and subsequently: setting the
language, channel and clock.
1 If the television is in Standby mode, press the POWER button
on the remote control.
Result:
The message PLUG & PLAY is displayed. It flickers for a
little while and then the LANGUAGE menu is automatically
displayed.
2 Move the joystick up or down to select required language. Press
the MENU button to enter the language, and then the message
ANT. INPUT : CHECK is displayed.
➣
If any language is not selected on the LANGUAGE menu, the
LANGUAGE menu will be displayed about 30 seconds later.
3 Make sure that the antenna is connected to the TV. And move the
joystick left or right.
Result:
The
AUTO STORE menu is displayed.
4 Select your area by moving the joystick left or right. The following
areas are available: ASIA/W.EUROPE - CIS/E.EUROPE - CHINA -
HONGKONG/UK - AUSTRALIA - NZ/INDONESIA - SOUTH AFRICA -
AMERICA.
5 To search the channels, select the SEARCH by moving the joystick
up or down, and then move the joystick left or right (refer to
“Storing the Channels Automatically” on page 17). Press the
MENU button to skip.
Result:
The TIME menu is displayed.
6 Move the joystick left or right to move to the hour or minute. Set the
hour or minute by moving the joystick up or down (refer to “Setting
and Displaying the Current Time” on page 31).
7 When you have finished, press the MENU button.
Result:
The message ENJOY YOUR WATCHING is displayed,
and then the channel which has been stored will be
activated.
PLUG & PLAY
ANT. INPUT : CHECK
SELECT EXIT
AUTO STORE
AREA : ASIA/W.EUROPE
SEARCH : -/+
SELECT ADJUST EXIT
TIME
CLOCK : -- : -- AM
TIMER : OFF
SELECT ADJUST EXIT
ENJOY YOUR WATCHING