Filter
Top Products
English - 31
Memorizing the Channels
Your TV can memorize and store all of the available channels for both “off-air” and cable channels.
After the available channels are memorized, use the CH and CH buttons to scan through the
channels. This eliminates the need to change channels by entering the channel digits. There are three
steps for memorizing channels: selecting a broadcast source, memorizing the channels (automatic)
and adding and deleting channels (manual).
1
Press the MENU button.
Press the … or † button to
select “Channel”, then press
the ENTER button.
2
Press the ENTER button to
to select “Air / Cable”
3
Press the … or † button to
select “Air”, “STD”, “HRC”
or “IRC”, then press the
ENTER button.
Press the EXIT button to exit.
NOTE
• STD, HRC and IRC identify various types of cable TV systems.
Contact your local cable company to identify the type of cable
system that exists in your particular area. At this point the signal
source has been selected. Proceed to “Storing Channels in
Memory” (Next page).
Selecting the Video Signal Source
Before your television can begin memorizing the available channels,
you must specify the type of signal source that is connected to the TV
(i.e., an air or cable system).
Air / Cable :Air
Auto Program
Channel Manager
Name
Fine Tune
LNA :Off
Channel
TV
Move Enter Return
Air / Cable : Air
Auto Program
Channel Manager
Name
Fine Tune
LNA :Off
Channel
TV
Move Enter Return
Air
STD
HRC
IRC
•
If you are using an Air antenna, leave “Air” displayed.
If you are using a cable antenna, press the … or † button to
display the type of cable system: “STD”, “HRC” or “IRC”.
(If you are not sure which type of cable system you have,
contact your cable company).
BP68-00588F-00Eng(026~047) 5/17/06 9:43 AM Page 31