Filter
Top Products
ENG-9
5 Press OK button.
6 Press OK to start the auto scanning.
◆
The number of stations automatically stored by
the STB-DVD-VCR depends on the number of
stations found.
◆
“AUTO” appears in the Front Panel.
7 The time and date are displayed automatically.
To set Time and Date, see page 10.
Auto setup
Please wait
00 %
Clock Set
Time Date Year
12 : 00 1 / JAN / 2004 THU
➢
Plug & Auto Set up tunes only the analog
broadcasting.
Tuning Your Television for the
STB-DVD-VCR
You must tune your television for the STB-DVD-VCR
only if you are not using a RCA cable
➢
To view pictures from your STB-DVD-VCR
when a RCA cable is used, the television must
be set to the audio/video mode (LINE).
1 Switch on the television.
2 Switch on the STB-DVD-VCR by pressing
STANDBY/ON on the front of the STB-DVD-VCR or
STANDBY/ON on the remote control.
3 Select a programme position on the television to be
reserved for use with your STB-DVD-VCR.
4 Insert the video cassette in the STB-DVD-VCR.
Check that the STB-DVD-VCR starts playing the
cassette; if not, press
❿
II
button.
5 Start tuning your television or set the television to
UHF channel 38.
6 Fine tune the television until the pictures and sound
are obtained clearly.
7 If you cannot find the pictures and sound, or there
is interference from nearby channels, it may be
necessary to change the setting of the STB-DVD-
VCR output channel (see Setting the STB-DVD-
VCR Output Channel on page 14 and
Troubleshooting Guide on page 49.
8 When the picture and sound are perfectly clear,
store this channel at the desired programme
position on the television.
Result: That channel is now tuned for use with
your STB-DVD-VCR.