Filter
Top Products
ENG-8
Plug & Auto Set up
The VCR section of the STB-DVD-VCR will
automatically set itself up when it is plugged into the
mains for the first time. TV stations will be stored in
memory. The process takes a few minutes. Your STB-
DVD-VCR will then be ready for use. Confirm the aerial
is plug to ANT.IN.
1 Connect the RCA cable as indicated on page 7.
(Connecting Your STB-DVD-VCR to the TV Using
the RCAAudio/Video Cable)
2 Plug the STB-DVD-VCR into the mains.
Result : The Language Set menu is displayed.
3 Select the required language by pressing the
or
❷
buttons.
4 Press OK to store the language selected.
Result: A message is displayed.
Connecting STB-DVD-VCR to a
Satellite Receiver or Other
Equipment
You can connect other audio and/or video equipment
to your STB-DVD-VCR in different ways. The following
illustrations give a few examples of the connection
possibilities.
➢
The RCA input/output connectors on the rear of
the STB-DVD-VCR are used for equipment, such
as camcorders, VCRs or sound systems.
REAR OF THE
STB-DVD-VCR
Camcorder
VCR
Sound system
To receive television programmes a signal must be
received from one of the following sources:
◆
An outdoor aerial
◆
An indoor aerial
◆
A cable television network
◆
A satellite receiver
☛
Make sure that both the television and the STB-
DVD-VCR are switched off before connecting the
cables.
1 Connect this the RF cable to the 75Ω coaxial
socket marked ANT.IN on the rear of your STB-
DVD-VCR.
2 Plug the coaxial cable supplied into the socket
on your STB-DVD-VCR.
3 Plug the other end of the coaxial cable into the
connector previously used for the aerial on the
television.
4 To obtain better quality pictures and sound on your
television, you can also connect your STB-DVD-
VCR to the television via the RCA cable (see
previous page) if your television is equipped with
this type of connection.
TV
3
2
1
Connecting STB-DVD-VCR to the
TV using the Coaxial Cable
TV