Filter
Top Products
ENG-7
Inserting Batteries in the Remote
Control
You must insert or replace the batteries in the remote
control when you:
◆
Purchase the STB-DVD-VCR
◆
Find that the remote control is no longer
working correctly
1 Push the tab in the direction of the arrow to release
the battery compartment cover on the rear of the
remote control.
2 Insert two AAA, RO3 or equivalent batteries,
checking for polarities:
◆
+ on the battery with + on the remote control
◆
– on the battery with – on the remote control
3 Replace the cover by aligning it with the base of
the remote control and pushing it back into place.
➢
Use same types of batteries
1
Display Indicators
108 9
7
1 The DVD Deck is active.
2 A DVD, CD is loaded
3 The time, counter position, time remaining or
current deck status is displayed
4 VHS tape is inserted
5 The VCR Deck is active
6 3D sound
7 DTS disc
8 STEREO indicator
9 REC Mode
10 ATimer Recording is programmed or in progress.
1 2 3 4 5
6
TV
1
Connecting STB-DVD-VCR to
the TV using the RCA Cable
You can connect your STB-DVD-VCR to the television
using the RCA cable if any appropriate Line input is
available on the television. You thus:
◆
Obtain better quality sound and pictures
◆
Simplify the setting up procedure of your
STB-DVD-VCR
☛
Make sure that both the television and the STB-
DVD-VCR are switched off before connecting
the cables.
1 Connect the aerial RF cable to ANT.IN on the rear
of your STB-DVD-VCR.
2 Use the RCAAudio/Video cable to connect the
STB-DVD-VCR and the TV receiver.
3 Use LINE OUT on the STB-DVD-VCR and LINE IN
on the TV.
3
2