Filter
Top Products
Connecting VHF and UHF Antennas
Antennas with 300 Q Flat Twin Leads
If you are using an air antenna(such as a roof antenna or "rabbit ears") that has 300£_twin fiat
leads, follow the directions below.
1 Placethe wires from thetwin leads under the screws on a 300-75 _ adapter(not supplied).
Use a screwdriver to tighten the screws.
2 Plug the adaptor into theANT IN terminal onthe back of the TV.
Antennas with 75 Q Round Leads
1 Plug the antenna lead into the ANT INterminal on the back of the TV.
Separate VHF and UHF Antennas
If you have two separate antennas for your TV(one VHF and one UHF),you must combine the
two antenna signals before connecting the antennas to the TV. This procedure requires an
optional combiner-adaptor(available at most electronics shops).
1 Connect both antenna leadsto the combiner.
2 Plug the combiner into the ANT INterminal on the back of the TV.
ANT IN
ANT IN
ANT IN
Connecting Cable TV
Cable without a Cable Box
1 Plug theincoming cable into the ANT IN terminal on the back of the TV.
Because this TV is cable-ready, you do not need a cable box to view unscrambled cable
channels.
a Cable Box that Descrambtes All Channels
1 Findthe cable that isconnected to the ANT OUT terminal on your cable box.
This terminal might be labeled "ANT OUT", "VHF OUT" or simply, "OUT".
2 Connect the other end of this cable to the ANT INterminal on the back of the TV.
ANT IN
ANT IN
to a Cable Box that Descrambles Some Channels
If your cable box descrambles only some channels(such as premium channels), follow the
instructions below. You will need a two-way splitter, an RF(A/B) switch, and four lengths of Antenna cable.
These items are available at most electronics stores.)
% IN CABL
Cable Box
ANT IN
cable _ _ _ _ _ _l =""_.\,_./,_ TVR
Splitter ] "''_ L J_ [ RF(A/B) ear
CableBox Switch
1 Find and disconnect the cable that is connected to the ANT
IN terminal on your cable box.
This terminal might be labeled 'ANT IN_, "VHF IN" or
simply, "IN".
2 Connect this cane to a two-way splitter.
3 Connect an Antenna cable between an OUT terminal on the
splitter and the iN terminal onthe cable box.
4 Connect an Antenna cable between the ANT OUT terminai
onthe cable box andthe B-IN terminai on the RF(A/B)
switch.
5 Connect another cable between the other OUT terminal on
the splitter and theA-IN terminal on the RF(A/B) switch.
6 Connect the lastAntenna cable between the OUT terminal on
the RF(A/B) switch andthe ANT IN terminal on the back of
the TV.
After you have made thisconnection, setthe A/B switch to the 'W'
position for normal viewing. Setthe A/B switchto the "B' position
to view scrambled channels. (When you set the A/B switch to "B",
you wilt need to tune your TV to the cable box's output channel,
which is usually channel 3or4.)