Filter
Top Products
English - 22
Contents (when Source is set to USB or TV Memory)
You can select a folder on the USB Device/TV memory with music or photo files to be played when the TV turns on
automatically.
If the folder name is too long, the folder can not be selected.
If you are using two of the same type USB device, be sure the folder names are different so the correct USB is read.
Repeat
Select Once, Everyday, Mon~Fri, Mon~Sat, Sat~Sun or Manual.
When Manual is selected, press the ► button to select the desired day of the week. Press the ENTER
E
button over the
desired day and the
c
mark will appear.
You can set the hour, minute and channel by pressing the number buttons on the remote control.
Auto Power Off
When you set the timer On, the television will eventually turn off, if no controls are operated for 3 hours after the TV was
turned on by the timer. This function is only available in timer On mode and prevents overheating, which may occur if a TV
is on for too long time.
Network Connection
You can set up the Internet Protocol so that you can communicate with various connected networks.
Network Connection - Cable
LAN Connection for a DHCP Environment
The procedures to set up the network using Dynamic Host Configuration Protocol (DHCP) are described below. Since an IP
address, subnet mask, gateway, and DNS are automatically allocated when DHCP is selected, you do not have to enter them
manually.
1.
Connect the LAN port on the rear panel of the TV and the external modem with a LAN Cable.
2.
Connect the Modem on the wall and the external modem with a Modem Cable.
You can connect the LAN via a Sharer (Router).
■
N
N
■
N
N
N
¦
❑
■
TV Rear Panel
The Modem Port on the Wall
External Modem
(ADSL / VDSL / Cable TV)
1 LAN Cable2 Modem Cable
TV Rear Panel
The Modem Port on the Wall External Modem
(ADSL / VDSL / Cable TV)
LAN CableModem Cable LAN Cable
IP Sharer
[7000]BN68-02077A-00Eng.indb 22 2009-03-11 �� 2:56:04