English
General settings
How to set 64
These settings are used to generate a warning buzzer
when the hard disk is full and at alarm events.
1
Display the <BUZZER SET> screen as explained in
"Displaying the general settings screen", and then
turn the S-dial clockwise. (P62)
The "OFF" field in the ALARM line starts blinking.
2
Turn the J-dial to select ON or OFF, and then turn
the S-dial clockwise.
Repeat the same procedure for selecting the desired
settings for each item.
• ALARM
OFF: Buzzer will not sound, even if an alarm is
detected.
ON: Buzzer will sound when an alarm is detected.
•DISK FULL
OFF: The buzzer will not sound, even if the hard
disk is full, and overwrite is disabled.
ON: The buzzer will sound if the hard disk is full,
and overwrite is disabled.
•DISK ERROR
OFF: The buzzer will not sound, even if a hard disk
error occurred.
ON: The buzzer will sound if a hard disk error
occurred.
• LOCK WARNING
OFF: The buzzer will not sound, even if the button
locked by the security lock is pressed.
ON: The buzzer will sound twice with a 0.5 sec
cycle if the button locked by the security lock
is pressed.
• KEY IN
OFF: The buzzer will not sound, even if the button
necessary for operation is pressed.
ON: The buzzer will sound, when the button
necessary for operation is pressed.
•NON REC
OFF: The buzzer will not sound, even if recording
was stopped.
ON: The buzzer will sound if the recording was
stopped.
3
Press the EXIT/OSD button.
☞ Press any operating button to stop the buzzer.
The buzzer can also be stopped by turning the S-dial or
the J-dial.
B Buzzer settings
MENU
(J)
(S)
<BUZZER SET>
ALARM : OFF
DISK FULL : ON
DISK ERROR : ON
LOCK WARNING : ON
KEY IN : OFF
NON REC : OFF
2.BUZZER SET
3.GENERAL SET
<MAIN MENU>
<GENERAL SET>
EXIT/OSD