Filter
Top Products
2 NAMES AND FUNCTIONS OF PARTS
8 English
INTRODUCTION
Rear panel
1. FAN
2. AUDIO IN terminal
3. AUDIO OUT terminal
4. LAN terminal (JP.39)
5. MIC IN terminal
6. VIDEO IN terminal
7. VIDEO LOOP OUT terminal
8. VIDEO OUT terminal
9. TV SYSTEM selector switch
Used to select the video signal between NTSC and PAL
systems for the camera input and TV monitor output
connected to the digital video recorder.
z Turn the power OFF then ON again after switching the
TV SYSTEM selector switch to NTSC or PAL.
10. Power cord holder
Secure the power cord to the holder using the cord tie
(accessory) as shown in the illustration.
11. AC INLET
AC power input terminal (3-core)
12. RS-485 TERMINATE switch (JP.48)
RS-485 termination ON/OFF switch
13. Control and alarm terminals
*
1
Used for twisted-pair cable connection.
*
2
NON REC is output when SERIES REC OUT is OFF.
*
3
The following warnings are output:
z Hard disk drive error z Fan error z Recording error
z No input signal when VIDEO LOSS is ON.
14. ALL RESET switch
Resets the clock and backup mode setting.
AUDIO
RS485
REMOTE
CLOCK
NON REC OUT/
SERIES REC OUT
ALARM RESET
ALARM OUT
ALARM IN
WARNING OUT
ALL
RESET
FULL OUT
ADJ
SERIES
REC IN
ABC C C
IN
OUT
LAN
VIDEO
MIC IN
IN
OUT
IN
LOOP OUT
OUT
TV
SYSTEM
RS485
TERMINATE
NTSC
OFF
ON
PAL
1325678
10 11 9 13
14
4
12
Cord tie
Pin Signal
RS-485A To RS-485 terminal signal A *
1
RS-485B To RS-485 terminal signal B *
1
C Common *
1
REMOTE For wired remote control (VA-RMN01)
C Common
CLOCK ADJ IN Input for clock setting
CLOCK ADJ OUT Output for clock setting
SERIES REC IN SERIES-REC input
NON REC OUT/
SERIES REC OUT
NON-REC output/
SERIES-REC output *
2
ALARM IN Alarm input
ALARM RESET Alarm reset input
ALARM OUT Alarm output
C Common
WARNING OUT Warning output *
3
FULL OUT Recording area full warning
e00_l8hae_us_7.book Page 8 Thursday, April 8, 2004 11:14 AM