Sanyo PLV-65WHD1 Projection Television User Manual


 
31
LAMP REPLACEMENT
The projection lamp has a service life and it needs to be
replaced when it reaches the end-of-life. When the lamp of
this LCD Projection TV reaches the end-of-life, the LAMP
REPLACE indicator will light yellow. If this indicator turns to
yellow, replace the lamp with a new one promptly.
LAMP
LAMP
REPLACE
REPLACE
WARNING
This indicator will light
yellow when the projection
lamp reaches the end-of-life.
For continued safety, replace with a lamp of the
same type. Do not drop a lamp or touch a glass bulb!
The glass can shatter and may cause injury.
Allow the LCD Projection TV to cool, for at least 30
minutes before you open the Lamp cover. The inside
of the LCD Projection TV can become very hot.
CAUTION
Lamp cover
Press and hold
this button and
pull the front
cover forward.
Press the latch
on both side.
Loosen two screws.
FRONT PANEL
CAUTION
Follow these steps to replace the lamp assembly.
1
Turn off the LCD Projection TV and unplug the AC
power cord. Allow it to cool for at least 30 minutes.
2
Press the latches on both sides of the front cover
and pull the front cover forward.
3
Loosen the screw that secures the lamp cover with
a screwdriver and remove the lamp cover.
4
Loosen the two (2) screws that secures the lamp
assembly and pull out the lamp by holding the holes
on both sides.
5
Replace the lamp with a new one and secure it with
the two (2) screws. Make sure that the lamp is
seated properly into the lamp compartment. (Refer
to page 32 for ordering the replacement lamp.)
6
Put back the lamp cover and secure it with the
screw, and then put back the front cover.
7
Connect the AC power cord to the Power Cord
Connector and turn on the LCD Projection TV.
8
Reset the lamp counter. See “Lamp Counter Reset”
on page 28.
CAUTION
When installing the new lamp into the lamp
compartment, make sure the lamp socket is
securely plugged into the compartment socket.
Improper or loosen socket connection may cause
arc discharge resulting fire hazard.
Loosen the screws.
Hold here and pull out
the lamp.
(There are holes inside)