Filter
Top Products
NORMAL RECORDING
Concerning the Number of Times Tapes
can be Rerecorded on
Depending on the recording speed mode, the tape must
be replaced after a certain number of recording times.
Refer to the table below for the maximum number of times
a tape can be recorded on.
Recording speed mode
(hour mode)
Maximum number of
recording times
(with a standard grade
tape)
2 100
12 50
24 50
48 25
72 15
NOTES:
X The maximum number of recording times will vary
depending on the location and kind of tape used. Verify
the recording quality and replace the tape when the
quality starts to deteriorate.
The maximum number of recording times indicated
above are based on test tapes (T-120) used by the
company.
X If using longer tapes (i.e. T-160) the tape travel will not
be as stable and that may cause problems.
Changes to the Recording Speed Mode
During Recording
It is possible to permit or prevent changing the recording
speed mode during recording.
1 Press the MENU button until the (SET UP 4) menu is
displayed.
@@@@@@@<SET@UP@4>
*SW@OUT
@@FIELD@@@@@@@@@01
@@TIMING@@@@@@@@FIELD
@@2H@@@@@@@@@@@@Y
*THREAD@CHECK@@@Y
*VIDEO@LOSS@@@@@N
*REC@SPEED@@@@@@N
2 Press the * (or +) button, until the “REC SPEED”
setting is flashing.
3 Press the l (or j) button to set the desired mode.
Y. . . . . . . . . . Recording speed mode can be
changed
N . . . . . . . . . Recording speed mode can not be
changed
4 Press the SEARCH/AUDIO ON button to save the
setting.
Action to Take when the Video Signal
Deteriorates
If there is no video signal during recording or when a
menu is not displayed (in stop, fast forward or rewind
modes), “VIDEO LOSS” can be displayed on-screen and
a signal (0 V) can be output at the ALARM OUT terminal.
If in the (SET UP 2) menu, in the BUZZER section
WARNING is set to “Y”, the buzzer will be heard. To stop
the buzzer, press the STOP button.
1 Press the MENU button until the (SET UP 4) menu is
displayed.
2 Press the * (or +) button, until the “VIDEO LOSS”
setting is flashing.
3 Press the l (or j) button to set the desired mode.
N . . . . . . . . . The video loss warning is not active.
Y. . . . . . . . . . The video loss warning is active.
4 Press the SEARCH/AUDIO ON button to save the
setting.
RC4Q/NA2 (TLS-9072 GB) Thu. Sept., 07/2000
English 17