Filter
Top Products
AUTOREPEAT RECORDING
Autorepeat Recording
The same tape can be recorded over many times.
X Follow the Before starting steps, under “NORMAL
RECORDING”.
1 Set the REPEAT REC switch to the “ON” position.
ø
The REPEAT indicator will light.
2 Press the MENU button until the (SET UP 3) menu is
displayed.
ø
The “ALARM MODE” setting is flashing.
@@@@@@@<SET@UP@3>
*ALARM@MODE@@@@@@@Y1
*ALARM@DURATION@@@20S
*TAPE@IN@MODE@@@@@STOP
*TAPE@END@MODE@@@@R1
*TAPE@END@OUT@@@@@-3M
*CLOG@DETECT.@@@@@Y
3 Press the * (or +) button, until the “TAPE END
MODE” setting is flashing.
4 Press the l (or j) button to set to “R 1” or “R 2”.
(Please refer to page 18, “Setting the Mode at the
End of the Tape.”)
5 Press the SEARCH/AUDIO ON button to save the
setting.
6 Press the REC/PLAY SPEED l (or j) button to set
the recording speed mode.
7 Press the REC button.
ø
Recording will start. When the tape end is
reached, the VCR will rewind it to the beginning,
and recording will resume.
ø
When the end of the tape is reached, a buzzer
will be heard (if in the (SETUP 2) menu, in the
BUZZER section TAPE END is set to “Y”) and
“OFF” will be displayed until the rewinding
operation starts.
NOTES:
X If during autorepeat recording there is an alarm trigger,
“AL” is displayed on the digital display and alarm
recording will take place. (Please refer to page 20,
“ALARM RECORDING”.)
X If the “TAPE END MODE” setting is R 1, the REPEAT
indicator will go off if there is an alarm trigger. After
alarm recording, the recording will continue to the end
of the tape then it will be rewound to the beginning and
stop. “OFF” will be displayed on the digital display. To
turn off the buzzer (if in the (SETUP 2) menu, in the
BUZZER section TAPE END is set to “Y”) and the
“OFF” display, press the STOP, EJECT, FF, REW or
PLAY button.
X If “AL” is displayed on the digital display and the “TAPE
END MODE” setting is R1, autorepeat recording is not
possible.
RC4Q/NA2 (TLS-9072 GB) Thu. Sept., 07/2000
English 19