SCEPTRE X37 Page29
For Analog Cable and Antenna TV Tuner Users
Note: The following instruction set is for TV tuner antenna, analog cable users only.
When using the TV for the first time, you must perform the channel scan to get all
correct channels by doing the following: Press the SOURCE AV button on the
remote controller to select the TV input signal labeled either Cable ### or Air
###. # represents numbers.
1. Press the MENU button to activate the On Screen Display (OSD) menu.
2. Press the LEFT/RIGHT button to select the TV SETUP function group.
3. Press the UP/DOWN button to select correct Cable/Air signal source.
4. Press the UP/DOWN button to select CH-SCAN function and then press
(button in the center of LEFT/RIGHT & UP/DOWN) to perform channel
scanning to obtain all available channels.
For Set-top Box Users (including Digital Cable, Satellite, other video
displaying devices)
Note: The following instruction set is for set-top box users (including digital cable,
satellite box, and other video devices)
1. Make sure your video cables are connected correctly to the back of the television
with the color matching all ports.
2. Press the SOURCE AV or SOURCE PC button on the remote controller to select
the TV input signal which you’ve connected the set-top box to.
• For the coaxial cable you would use the source labeled TV.
• For the HDMI to HDMI cable you would use the source labeled HDMI.
• For the HDMI to DVI cable you would use the source labeled HDCP.
• For the component cables you would use the sources labeled YPbPr1 or
YPbPr2.
• For the RCA cables you would use the source labeled AV1 or AV2.
3. Please consult your set-top box’s manual with regards on how to turn on the
device and browse channels.