Filter
Top Products
Getting Started
First-Time Operation
The steps below will help you get your TV connected and
x,orking quickly. The page numbers on which you can
find detailed instructions for each of these steps are also
listed for your convenience.
1. Unpack TV and accessories.
Shown here are the accessories thatcame packed with your TV.
An.oa--r
Remote Control and
Four AAA Batteries Power Cord
2. Install batteries in remote control.
Details are on page 6.
3. Connect antenna or cable-TV system.
Most antenna or cable-TV systems can be connected as
shown here.
Incoming Cable from Antenna or
Cable-TV System
Back
of TV
CABLEJ_NTENNA
tog
• Details for connecting a home antenna to your TV
are on page 20.
• Details for connecting a cable-TV system to your TV
are on page 21.
• Details for connecting a VCR to your TV are on
pages 27-28.
4. Attach power cord.
First attach the flat end of the power cord completely into the
connector on the back of your TV, and then plug the other
end into a wall outlet.
Do This Not This
5. Turn on TV, adjust the volume, and select a channel.
est ttonote
e =7CHAN(Channel)
Buttons
VOL (Volume)
Buttons
down button to adjust the
volume to a desired level.
• Press the CHANNEL up or down button to select the next
channel in memory. You can also press two number buttons
to select a channel. To select a 3-digit cable channel (up to
channel 128), press and hold number button 1 until 1--
appearson the screen. Then press the other two numbers.
Channels 2-13 were programmed into the channel memory
for you at the factory, so pressing CHANNEL up or down
stops at these channels only. When you start the
autoprogramming feature (described in step 6), your set will
automatically scan through all channels and place only the
active channels for your area into its channel memory.
• Details about using the remote are on page 6.
6. AutoProgram the
TV's channel memory.
To start the TV
autoprogramming itself,
press the SETUP button
repeatedly to select
(highlight) the
A UTOPROGRAM
function, and then press +.
Details are on page 16.
-Bu_on--
t:>O0_
o0b_
_'_'_'_,,_ + Button
You can also add and erase
channels from memory as
desired by first pressing
SETUP to select (highlight) the
CHAN MEM function.
Select the desired channel
number by pressing the
CHANNEL up.or down button
or by pressing the tw_
corresponding number buttons.
Then press + to add a channel,
or press - to erase a channel.
Details are on page 16.
2