Filter
Top Products
4) On the UPS Interface Configuration screen (shown below, left), enable the UPS Signal Polarity options as illustrated.
Click ‘Finish’ to return to the Power Options Properties screen (see screen on previous page, left). Press the
‘Configure...’ button on the Power Options Properties screen to proceed to the UPS Configuration screen (shown below,
right).
5) On the UPS Configuration screen (above right), configure the options as shown.
6) Press ‘OK’ to return to the Power Options Properties screen (see screen on previous page, left). To commit the new
settings, choose ‘OK’ or ‘Apply’. The UPS Service will attempt to enable.
Remote Power On/Off Appendix C | Windows NT/2000/XP ShutDown • 55