Filter
Top Products
17
Child Lock
Allow you to use a PIN to protect certain settings from
being accidentally changed.
Changing the PIN
1 Press MENU and the MENU screen displays.
2 Press c/d to select “Setup”.
3 Press a/b to select “Child Lock”, and then press
OK.
New PIN
–––
Reconfirm
––––
–
Change PIN
Reset
4 Enter the 4-digit number as a PIN using 0 – 9.
5 Enter the same 4-digit number as in step 4 to
confirm.
• “The system PIN has been changed successfully”
displays.
NOTE
• To view a locked channel, you must enter a PIN. (See
pages 16 and 27 for locking channels from viewing in
analogue TV and DTV mode.) When you select a locked
channel, a PIN prompt message pops up. Press OK to
display the PIN input window.
Menu operations
Input Label
You can assign each input source a label you like.
1 Press b to select the desired input source.
2 Press MENU and the MENU screen displays.
3 Press c/d to select “Setup”.
4 Press a/b to select “Input Label”, and then press
OK.
5 Press a/b/c/d to select each character of the
new name for the input source, and then press
OK.
6 Repeat step 5 above until the name is fully spelt
out, and then press OK.
• The name can be 6 characters or less.
• If a label name is less than 6 characters, select
“END”, then press OK.
NOTE
• You cannot change the label if the input source is TV or
DTV.
TV only
Fine Sync.
Menu Operation: C (Page 12)
Ordinarily, the TV automatically adjusts image positions
coming from PC (Auto Sync. function). In some cases,
however, manual adjustment is needed to optimise the
image.
H-Pos.: Centres the image by moving it to the left or right.
V-Pos.: Centres the image by moving it up or down.
Clock: Adjusts when the image flickers with vertical
stripes.
Phase: Adjusts when characters have low contrast or
when the image flickers.
PC only
NOTE
• If you need to adjust the image position, adjust the position
using your PC.
Erase Programme
An individual programme can be erased.
1 Repeat steps 1 to 4 in Programme Setup.
2 Press c/d to select “Ye s ”, and then press OK.
3 Press a/b/c/d to select the channel you want
to erase, and then press OK.
• A message screen pops up.
4 Press c/d to select “Ye s”, and then press OK to
erase the selected programme. All the subsequent
programmes move up.
5 Repeat steps 3 and 4 until all desired channels
are erased.
Resetting the PIN
Allow you to reset your PIN to the factory preset “1234”.
1 Repeat steps 1 to 3 in Changing the PIN.
2 Enter the PIN.
3 Press a/b to select “Reset”, and then press OK.
4 Press c/d to select “Ye s ”, and then press OK.
NOTE
• As a precautionary measure, make a note of your PIN
on the back of this operation manual, cut it out and
keep it in a safe place that children cannot reach.
• See page 32 for resetting the current PIN to the factory
preset “1234” if you lose or forget your PIN.
Item